摘要:
采用真空负压灌注技术,结合溶胶-凝胶法在多孔氧化铝模板的纳米孔洞中成功制备了平均直径为80 nm左右的Ni1-xMnxFe2O4（X=0,0.25,0.5,0.75）纳米线阵列.XRD结果显示所制备的纳米线阵列为立方尖晶石结构,SEM和TEM的结果表明纳米线是由大量不同晶体取向的亚微晶粒联接组成.磁测量结果显示,随着Mn掺杂浓度的增加,饱和磁化强度先增加而后减小,这种变化与离子在尖晶石结构中的替代、占位变化有关.相比于块体材料的NiFe2O4,由于非线性磁结构比例的增加,导致了线体NiFe2O4的饱和磁化强度降低.
Abstract:
of Ni1-xMnxFe204 （z = 0.0, 0.25, 0.5, 0.75） nanowires with an average diameter of about 80 nm are prepared by porous anodic aluminum oxide membrane poured sol technique. X-ray diffraction analysis shows that the nickel manganese ferrites nanowires with cubic spinel structure are synthetized. Scanning electron microscopy and transmission electron microscope images indicate that the nanowire arrays are composed of prolate spheroids with different crystal orientations. Magnetic measurements show that saturation magnetization increases and then decreases with Mn increasing. The change is related to the location and the substitution of ion in spinel structure. Compared with of block material NiFe204, the saturation magnetization of nickel ferrite nanowire arrays is low. This is due to the fact that the noncollinear magnetic structure in nanowire arrays become predominant.
首页
登录
注册
下载: