[1] 范永山, 杜畅通, 张化一, 等. XiPAF重离子同步加速器超高真空系统的设计[J]. 工程科学与技术, 2023 (in Chinese) Fan Y S, Du C T, Zhang H Y, et al. Design of an ultra-high vacuum system for the XiPAF heavy-ion synchrotron[J]. Advanced Engineering Sciences, 2023
[2] 罗艳, 王魁波, 吴晓斌, 等. 高精度真空材料放气测试研究[J]. 真空科学与技术学报,2016,36(3):251−257 (in Chinese) Luo Y, Wang K B, Wu X B, et al. High-precision measurement of outgassing rates of materials for use in extremely high vacuum[J]. Chinese Journal of Vacuum Science and Technology,2016,36(3):251−257
[3] 张军辉, 杨晓天, 蒙峻, 等. 真空炉高温除气工艺对降低不锈钢出气率的作用[J]. 真空与低温,2003,9(2):105−108 (in Chinese) doi: 10.3969/j.issn.1006-7086.2003.02.009 Zhang J H, Yang X T, Meng J, et al. The effect of the vacuum furnace degassing for reducing the stainless steel out-gassing rate[J]. Vacuum & Cryogenics,2003,9(2):105−108 doi: 10.3969/j.issn.1006-7086.2003.02.009
[4] 张涤新, 曾祥坡, 冯焱, 等. 材料放气率测量方法评述[J]. 真空,2010,47(6):1−5 (in Chinese) Zhang D X, Zeng X P, Feng Y, et al. Review of measuring methods of outgassing rate[J]. Vacuum,2010,47(6):1−5
[5] Mahner E. The vacuum system of the low energy ion ring at CERN: Requirements, design, and challenges[J]. Vacuum,2007,81(6):727−730 doi: 10.1016/j.vacuum.2005.11.054
[6] 万亚鹏, 蒙峻, 罗成, 等. HIAF薄壁二级铁真空室在线烘烤方案研究[J]. 真空科学与技术学报,2017,37(10):957−962 (in Chinese) Wan Y P, Meng J, Luo C, et al. In-situ bake-out scheme for thin-walled dipole magnet extreme high vacuum chamber of high intensity heavy-ion accelerator[J]. Chinese Journal of Vacuum Science and Technology,2017,37(10):957−962
[7] 冯焱, 董猛, 吴晓斌, 等. 基于分压力测量的真空材料放气率测试方法研究[J]. 真空,2013,50(4):49−52 (in Chinese) doi: 10.3969/j.issn.1002-0322.2013.04.011 Feng Y, Dong M, Wu X B, et al. Study on method for measuring vacuum materials partial outgassing rate[J]. Vacuum,2013,50(4):49−52 doi: 10.3969/j.issn.1002-0322.2013.04.011
[8] Ishizawa K, Kurisu H, Yamamoto S, et al. Titanium materials for UHV/XHV systems[C]//Proceedings of 2006 International Symposium on Discharges and Electrical Insulation in Vacuum, Matsue, Japan: IEEE, 2006: 805−808
[9] 冯焱, 曾祥坡, 张涤新, 等. 小孔流导法材料放气率测量装置的设计[J]. 宇航计测技术,2010,30(3):66−69 (in Chinese) doi: 10.3969/j.issn.1000-7202.2010.03.016 Feng Y, Zeng X P, Zhang D X, et al. Design of measurement apparatus for material outgassing rates by orifice conductance method[J]. Journal of Astronautic Metrology and Measurement,2010,30(3):66−69 doi: 10.3969/j.issn.1000-7202.2010.03.016
[10] 王勇, 李格. 永磁体钕铁硼的热出气率[J]. 真空科学与技术学报,2000,20(4):296−299 (in Chinese) Wang Y, Li G. Thermal outgassing of NdFeB permanent magnets[J]. Vacuum Science and Technology (China),2000,20(4):296−299
[11] 董猛, 冯焱, 成永军, 等. 材料在真空环境下放气的测试技术研究[J]. 真空与低温,2014,20(1):46−51 (in Chinese) doi: 10.3969/j.issn.1006-7086.2014.01.010 Dong M, Feng Y, Cheng Y J, et al. Measurement study for vacuum materials outgassing[J]. Vacuum & Cryogenics,2014,20(1):46−51 doi: 10.3969/j.issn.1006-7086.2014.01.010
[12] 杨晓天, 蒙峻, 张军辉, 等. 不锈钢材料在真空炉高温除气后的出气性能比较[J]. 真空,2004,41(3):24−26 (in Chinese) doi: 10.3969/j.issn.1002-0322.2004.03.007 Yang X T, Meng J, Zhang J H, et al. Outgassing comparison of stainless steel before and after high-temperature degassing by vacuum furnace[J]. Vacuum,2004,41(3):24−26 doi: 10.3969/j.issn.1002-0322.2004.03.007
[13] 陈蕾, 肖梅, 张晓兵, 等. 导线在真空环境中的放气特性分析[J]. 真空与低温,2016,22(2):100−103 (in Chinese) doi: 10.3969/j.issn.1006-7086.2016.02.008 Chen L, Xiao M, Zhang X B, et al. The outgassing characteristics analysis of the wire in the vacuum environment[J]. Vacuum & Cryogenics,2016,22(2):100−103 doi: 10.3969/j.issn.1006-7086.2016.02.008
[14] 成永军, 李得天, 张涤新, 等. 极高真空校准室内残余气体的成分分析[J]. 真空科学与技术学报,2010,30(1):54−59 (in Chinese) doi: 10.3969/j.issn.1672-7126.2010.01.11 Cheng Y J, Li D T, Zhang D X, et al. Composition analysis of residual gases in extremely high vacuum calibration chamber[J]. Chinese Journal of Vacuum Science and Technology,2010,30(1):54−59 doi: 10.3969/j.issn.1672-7126.2010.01.11